>
150 micro-points of pressure on your forehead just replaced the human eye.
Your body has a recycling plan for starvation, and it took a Nobel Prize to prove it.
I'm literally blown away by the amount of people that fell for the total garbage that they got..
Worth the Risk: How Risk, Failure, and Bankruptcy Make America Better
Jetson ONE personal eVTOL pod is about to go full sky patrol
America's INSANE BREAKTHROUGH Could Replace Septic Tanks Forever
Amazing DIY Building Material for Home & Yard - Inexpensive and Easy!
Researchers have discovered a massive deposit of hidden water...
Amazon's Ring Unveils Flying Drone And Robot To Patrol Homes And Businesses
Anthropic Strikes $3.4 Billion Off-Grid Power Agreement to Bypass U.S. Grids, Reports Say
The X-ray room just shrank to the size of a laptop
Dead Simple Apocalypse Power: Build It in an Hour
Gritt and MasTec partner to bring physical AI to solar construction sites
Baby it's cold INSIDE! Scientists create the coldest temperature ever recorded in the lab...

Electric boats are very slowly rising in popularity, and that's great for the companies that make them and for the people who have enough money to buy a finished product with all the bells and whistles.
However, for someone who wants a small, very powerful, and very fast electric jet boat, there aren't any real options out there. The people behind the Prop Department YouTube channel figured that out on their own, but instead of lamenting, they started building the mini jet boat of their dreams themselves.
We're talking about a completely custom job, with a hand-made hull and battery enclosures, as well as a custom electric motor, controller, and inverter. The project started three years ago, and the mini boat was initially powered by a Tesla Model 3 motor that made roughly 280 horsepower.
That's plenty for most people, but not for these guys. So they upgraded to a custom-tuned Tesla Model S motor that's good for over 350 hp. Then, two of the four battery modules were swapped with fresh ones because the original setup had a couple of dead cells that cut all power output when pushing the throttle a little too far.
An aftermarket BMS was used, and each custom module is liquid-cooled, just like on the original Tesla pack. A custom stub shaft that was fitted directly to the output shaft of the motor, eliminating the need for the original transmission and increasing the final RPM.
Tying everything together is an aftermarket controller board for the motor inverter, which enables the tinkerers to control the drive unit however they want without being limited by Tesla's safety guards.
There's a J1772 charge port, so no fast charging here, but it's still such an impressive project that was three years in the making, and there's still a lot of small things to finish. And, more importantly, it's a hoot to drive, with more than enough power for such a small hull.